Aplica Aislamientos

Adhesive mortar composed of cement, limestone aggregates Controlled granulometry and special additives which Improve their adherence, open time and Water repellent capacity.

Classified as GP CS IV W2according to standard UNE-EN 998-1

Aplica Aislamientos
Aplica Aislamientos
Instructions for use

  1. Check that the application surface is suitable and ready
    for use.
  2. Mix mechanically, adding water gradually until you
    obtain a smooth, lump-free paste of the required
    consistency.
  3. Apply evenly, then level out the mortar, covering the
    surface with a minimum thickness of between 4 mm
    and 6 mm.
  4. Place the panels on top of the mortar while it is still
    freshly-laid (open time approx. 20 mins.), pressing down
    with your hands.
  5. If the joints between the panels are less than 5 mm
    wide, they do not need to be sealed. In very cold or
    humid areas, sealing joints with adhesive tape is
    recommended.
  6. Once the insulation panels have been installed, seal the
    chamber by overlapping the panels.
Warnings and recommendations
  • Do not apply onto plaster or painted surfaces.
  • Do not apply at temperatures below 5°C or above 35°C.
  • Do not apply thicknesses of more than 15 mm.
    It is advisable to moisten absorbent or very hot surfaces
    before applying the product.
  • Do not apply onto damp-proof surfaces.
  • This product is ready to mix with water. Do not add any
    kind of additional substance which may alter its
    properties.
  • Use within 1 year of packaging date. Store the product
    in its original packaging in a dry, covered place
    protected from humidity.
Technical Features

Available Formats

aplica Aislamientos is available in 25 kg paper sacks with moisture-proof plastic lining, dispatched on pallets weighing a total of 1,600 kg (64 sacks).

 
 
Applications
  • Indoor and outdoor finishing on brick or concrete
    blocks, for the installation of mineral wool insulation
    panels. Apply by hand or using a spray machine onto
    clean, dry, non-shrinking surfaces.
    aplica Insulation waterproofs façades but is also water
    vapour permeable.
Note

The recommendations for use are based on our own knowledge and experience. The technical data provided have been obtained under normal laboratory conditions, and may therefore vary according to the environmental conditions in the place where the product is used. As the application conditions are beyond our control, the information provided here does not imply that the company accepts responsibility for any variations.

 
 

DOCUMENTATION

Download technical data sheet

Download Material safety data sheet
ECOETIQUETADO

Declaraciones Medioambientales

Concienciados con el medioambiente

Saber más