Resin-based dispersion adhesive for laying ceramic tiles on indoor walls.
aplicaCer Pasta Adhesiva D1
Instructions for use
Stir aplicaCer Pasta Adhesiva until thoroughly mixed.
Spread aplicaCer Pasta Adhesiva over the application surface, using a trowel with a tooth spacing no greater than 4 mm.
Press down on the tiles to ensure that all grooves are filled. Leave a joint at least 2 mm wide.
Wait 24 hours, then grout using aplica Color.
Warnings and recommendations
Do not apply at temperatures below 5°C or above 35°C.
Do not apply with a trowel with a tooth spacing greater than 4 mm.
Do not apply on surfaces exposed to permanent moisture.
Not suitable for outdoor use.
Do not apply on surfaces which are exposed to direct sunlight, nor on hot surfaces.
Not suitable for use with non-absorbent ceramic tiles on non-absorbent surfaces.
The maximum weight of tiles which can be glued using aplicaCer Pasta Adhesiva is 30 kg.
Do not lay tiles larger than 30 x 30 cm (900 cm²).
Use within 1 year of date of packaging. Store the product in its original packaging in a dry, covered place protected from humidity.
aplicaCer Pasta Adhesiva D1 is available in 25 kg and 6 kg plastic containers.
The application surfaces must be fl at, solid, clean and free from dust and traces of loose particles.
They must be free from all traces of paint, lime, oils and release agents.
For use with all types of ceramic tiles for indoor walls.
Suitable for use on deformable surfaces. Suitable for tiling any type of plasterboard.
Tiling on plaster in good condition. Gluing on wood on walls. Gluing on old tiles in good condition.
The recommendations for use are based on our own knowledge and experience. The technical data provided have been obtained under normal laboratory conditions, and may therefore vary according to the environmental conditions in the place where the product is used. As the application conditions are beyond our control, the information provided here does not imply that the company accepts responsibility for any variations.