1. Mix mechanically with clean water until you obtain a smooth paste of the required consistency.
2. Leave to stand for 2 – 5 minutes before applying.
3. Check that joints are clean and free from any dust or adhesive.
4. Moisten the application surface if weather conditions require it.
5. Fill each joint with paste using a rubber trowel. Carry out the ? nishing process once the top of the mortar has started to harden.

• Do not apply at temperatures below 5°C or above 35°C.
• Do not apply when frost or rain are forecasted.• Avoid applying when direct sunlight is shining on the
  application surface.
• Always use the exact required amount of water.
• For joints exceeding 15 mm in width or depth, add 4 litres of aplica Latex per 20 kg bag and 1 litre per 5 kg bag and ?ll with water until optimal consistency.

R = 1,82 x Z x H x (10/Z + 10/Y). R= Yield: kg/m2
Z: Joint Width in cm
H: Joint Depth in cm
X: Tile Width in cm
Y: Tile Length in cm
1.82: Paste density (kg/l)

aplica Color 0-15 is available in 20 kg paper bags,  dispatched on pallets weighing a total of 1.280 kg. Also available in 5 kg paper sacks with moisture-proof plastic lining, dispatched on shrink-wrapped pallets weighing a total of 800 kg (32 sacks).