1. Shake aplicaFill Fibras by manual or mechanical
   means for homogenisation before use.
2. The application can be done either by wool roller,
   brush or airless spray equipment.
3. Apply a first coat of product diluted 1:3
   (water:aplicaFill Fibras) to allow penetration into
   all cracks and crevices.

• Do not use aplicaFill Fibras in locations where it is in permanent contact with water, either through storage, waterlogging or condensation.
• aplicaFill Fibras is a finishing product. It is not a coating for frequent passability, but for visitable.
  Do not place any sharp objects onto the product.
• Surface temperature/application of + 5ºC / 35ºC.
  Do not apply if rain is forecasted in the next few hours.
• Tools should be washed with clean water immediately after use.

For applications in vertical surfaces as well as for roofing:

• 1 priming coat with diluted aplicaFill (1:3) in the case of porous surfaces.
• 2 aplicaFill coats (a fibreglass mesh can be used in roofing between the two coats, with the first coat still fresh and the second coat with the first coat once dry).

• Waterproofing of roofs on many types of supports
  (Catalan floor tiles, roofing tiles, bricks, mortars,
  concrete, fibre cement, polyurethane foam, aluminium,
  wood, zinc…)
• Vertical faces
• Protection of dividing walls
• Canalizations
• Treatment of meeting points
• Crack bridging
• Tile repair