1. Gradually mix the mortar with water (3,25 – 3,5 litres per 25 kg sack). Do not use too much water.
2. Mix mechanically with clean water at low rpm until you obtain a smooth, fluid paste.
3. To make the best use of the mortar’s expansive properties, pour it onto the application surface immediately after mixing.

• Do not apply the product at temperatures below 5°C or above 35°C.
• Do not apply when frost or rain are forecasted.
• Always use the exact amount of water specified.
• Moisten the application surface.
• This product is ready to mix with water.
• Do not add any kind of additional substance which may alter its properties.
• This product is not recommended for surface levelling.
• We recommend wearing rubber gloves when handling this cementlike product.
• When filling under plates, always ensure that there is a hole through which the air displaced by the mortar can escape.
• All tools must be washed immediately after use. If the product is allowed to dry, it will only be possible to remove it by mechanical means.

aplicaTec Grout SR is available in 25 kg paper sacks with moisture-proof plastic lining, dispatched on shrink-wrapped pallets weighing a total of 1,000 kg (40 sacks).

Storage: up to 12 months after manufacturing date in suitable temperature and humidity conditions.

• The surfaces onto which the product is applied must be clean, sound and free from oils, grease and paint.
• Any metal elements must be free from rust.
• Absorbent surfaces should be saturated with water before the product is applied. Make sure that no puddles form on the surface.

• Anchorings for metal elements, concrete or machinery.
• Filling bedplates by pouring under support plates.
• Filling hollows in concrete.
• Supporting beams in bridges.
• Fixing bolts.
• Reinforcing concrete elements through casing.
• Suitable for use in areas with gypsum-rich soils.