aplicaTec Reparación Epoxi 190

Mortar for structural repair of fast forging, single-component and without retraction.

CE marking as class R3 PCC according to EN 1504-3 (Products for the protection and repair of concrete structures).

aplicaTec Reparacion Epoxi 190
aplicaTec Reparación Epoxi 190
How to use



1. Knead with a mechanical mixer at low
revolutions gradually adding 5 liters of clean water per 25 kg bag. for a period of 2 minutes.
2. Manually apply the product on the previously conditioned surface.
3. Fill the entire gap by applying the product in successive, well-compacted layers.
4. Proceed to its completion with a trowel, sponge or using the same application tool.
5. As soon as the product loses its workability, stop using it and prepare a new material for its application.

Precautions and recommendations

• Do not apply the product at temperatures below 5oC or above 35oC.
• Do not apply with forecast of rain or frost.
• The absorbent supports will become wet to saturation but without puddling.
• This product is ready to mix with water, do not add any kind of additive that could
alter its properties.
• Under unfavorable conditions (low relative humidity, wind, sun, etc.) curing is
essential for at least 24 hours after application.
• As it is a cementitious product, the use of rubber gloves is recommended.
• The tools and supplies will be cleaned with water immediately after use, if the
product hardens they can only be removed by mechanical means.
• Conservation: 12 months from the date of manufacture of the product in adequate
conditions of temperature and humidity.

Presentation

Aplicatec Reparación Epoxi 190 is presented in 25 kg paper bags with anti-humidity plastic sheet on 1.000 kg pallets (40 bags).

Applications

Surface repairs of structural and non-structural concrete. Filled with coqueras. Repairs to cornices, slab edges and balconies. Realization of half reeds. Fixings for window frames and pre-frames. Fine plaster on concrete and mortar. Suitable for repair work, according to principle 3, method 3.1 and 3.3 of the UNE-1504-9 standard and for structural reinforcement work, according to principle 4, method 4.4 of the UNE-1504-9 standard.

Note

The recommendations for use are based on our knowledge and experience. The technical data have been obtained under normal laboratory conditions, and may vary depending on the conditions of use. Since the application conditions are not controllable on our part, the information on this sheet does not imply responsibility of the company.

ECOETIQUETADO

Declaraciones Medioambientales

Concienciados con el medioambiente