1 Gradually mix the mortar with water (3,75 litres per 25 kg / 15 % sack).

2 Mix mechanically with clean water at low rpm until you obtain a smooth, lump-free paste.

• Do not apply the product at temperatures below 5°C or above 35°C.
• Do not apply when frost or rain are forecasted.
• This product is ready to mix with water. Do not add
any kind of additional substance which may alter its
properties.
• Never add water on the mortar that has lost its
workability as it will lose its properties.
• In unfavourable conditions, the surface must be cured
for at least 24 hours after the product has been
applied.
• We recommend wearing rubber gloves when handling
this cement-like product.
• All tools must be washed immediately after use. If
the product is allowed to dry, it will only be possible to remove it by mechanical means.

• Alta fluidez.
• Elevadas resistencias mecánicas iníciales y finales.
• Elevado modulo de elasticidad para la transferencia de cargas.
• Retracción compensada.
• Resistente a la carbonatación.
• Exento de cloruros.
• Bajo contenido en cromatos.
• Protección del armado frente a la corrosión.
• Resistente a ciclos de hielo-deshielo.
• Alta adherencia sin el empleo de imprimación.
• Muy baja permeabilidad.
• Permeable al vapor de agua.
• Superfi cie lista para pintar.
• Válido para aplicación con llana o mediante bombeo en vía húmeda.
• Válido tanto en interior como en exterior.
• Clasifi cación al fuego A1fl.

aplicaTec Reparación Fluido R4 PCC is part of a repair system comprising:
• aplicaTec Armaduras: Anti-corrosion primer.
• aplicaTec Reparación R4 PCC / aplicaTec Reparación Fluido R4 PCC: Structural repair mortar.
• aplicaTec Reparación Fino R3 PCC / aplicaTec Cosmético Claro R2 PCC : Levelling mortars and pore sealant.

aplicaTec Reparación Fluido R4 PCC is available in 25 kg paper sacks with moisture-proof plastic lining, dispatched on shrink- wrapped pallets weighing a total of 1,000 kg (40 sacks).
Storage: up to 12 months after manufacturing date in suitable temperature and humidity conditions.

• The application surface must be prepared before application using manual or mechanical means to remove all the deteriorated concrete.
• The surfaces on which the product is applied must be clean, sound and free from oils, grease, paint, dust, cement grouts, etc.
• Metal elements such as reinforcement bars must be free from rust. • Remove the back of concrete reinforcement.
• Cut the ends of the repair to ensure a minimum application
thickness of 5 mm.
• Apply previously aplicaTec Steel Rebars for additional protection
or if the coating is less than 10mm.
• Absorbent surfaces should be saturated with water before the
product is applied. Make sure that no puddles form on the surface.

• Structural integrity repair of horizontal concrete elements for direct disposal.
• Repair and reinforcement (pillars, columns, walls ...) using formwork release by increasing the carrying capacity of the structures.
• Filling gaps, cracks, chips, corners of pillars...
• Suitable for repair work according to principle 3,
method 3.1 and 3.3 of the standard UNE-EN 1504-9 and structural reinforcement work according
to principle 4, method 4.4 of the UNE-EN 1504-9.