Capa Dry

Waterproofing mortar for a watertight finishing.

Mortar made of cements, aggregate, waterproofing polymers and special additives. For indoor and outdoor use. Pressure and counter pressure waterproof.

Capa Dry
Capa Dry
Instructions for use

  1. Add water and mix by hand or mechanically until you obtain a smooth paste of a workable consistency.
  2. Leave the paste to stand for 5 minutes and mix again before applying.
  3. Moisten the application surface and apply a thick first coat with a flat brush.
  4. Leave to dry for 2 to 4 hours.
  5. Apply a second coat with a flat brush.
  6. Trowel or smooth the mortar to achieve the desired finishing.
  7. Wait at least 4 days before filling the tank
Warnings and recommendations
  • Do not apply this product when frost or rain are forecasted.
  • Do not apply at temperatures below 5°C or above 35°C.
  • To ensure that the mortar provides optimum water resistance, minimum thickness must be of 5 mm.
  • In extreme weather conditions (wind or high temperatures), the product will dry quicker than usual. This will result in a shorter open time application.
  • In high temperatures, windy conditions or if the application surface is very absorbent, it is advisable to moisten the surface and wait for the film of water to disappear before applying the product.
  • Use within 1 year of packaging date. Store the product in its original packaging in a dry, covered place protected from humidity.
Technical Features

Available Formats

Capa Dry is available in 25 kg paper sacks with moisture-proof plastic lining, dispatched on pallets weighing a total of 1,600 kg (64 sacks).

Application Surfaces
  • Concrete, prefabricated concrete blocks and hard, cementrich renderings.
  • The application surface must be hard, perfectly set and free from dust, paint, oil, etc.
  • Waterproofing of structures such as swimming pools, terraces, basements, lift shafts, water tanks, retaining walls.
  • To protect buildings from moisture. Foundations, outside walls, terraces, balconies, drains…

The recommendations for use are based on our own knowledge and experience. The technical data provided have been obtained under normal laboratory conditions, and may therefore vary according to the environmental conditions in the place where the product is used. As the application conditions are beyond our control, the information provided here does not imply that the company accepts responsibility for any variations.


Declaraciones Medioambientales

Concienciados con el medioambiente