• Mix mechanically with clean water (7.5 l/bag – 8.5 l/bag) until a homogeneous and workable consistency is achieved.
• Let the kneaded adhesive rest for 5 min and re-knead before application.
• Spread the paste on the support in sections no longer than 2 meters, combing with the appropriate trowel. Follow the indications for use defined in the UNE-EN 138002 table.
• Place the ceramic pieces on the fresh gel adhesive, pressing them gently until complete contact with the entire surface is achieved, flattening the grooves.
• For the treatment of joints between tiles both indoors and outdoors, as well as perimeter and structural joints, follow the indications for use defined in the tables of the UNE-EN138002 standard.

Do not apply on weak and cohesive supports.
Do not apply at temperatures below 5ºC or above 45ºC.
Do not apply with risk of frost or rainy weather.
For applications on supports or derivatives of plaster or anhydrite, previously use our adherent primer CAPA PRIMER TOP.
In extreme weather conditions (wind and high temperatures) it dries faster than normal, causing a reduction in the open application time.
In the event of high temperatures, wind and highly absorbent supports, it is advisable to moisten the support and wait for the water film to disappear before applying the material.
Check the stickiness of the paste by periodically lifting a tile placed and observing that it is well adhered.
Apply the product following the indications contained in the laying regulations UNE.EN 138002 and in accordance with the instructions that appear in the technical data sheet. For any doubt, consult the Technical Department.
Use it within 1 year from its packaging date and store in a covered and dry place in its original packaging, away from moisture.

Se presenta en envases de 25 kg, conformados sobre palets retractilados en formatos de 1000 kg, 1400 kg y 1600 kg.

The surfaces must be cured and clean of dust, paint and oil. Avoid dead plaster and weak plaster.
The product can be used on plasterboard surfaces or on conventional surfaces such as plaster and concrete floors, as well as on cellular concrete.
For applications on surfaces or derivatives of gypsum or anhydrite, previously use our adherent primer CAPA PRIMER TOP.
In case of use on surfaces or with tiles not defined in the technical sheet of the material, consult the Technical Department.

Recommendations for use are based on our knowledge and experience. The technical data have been obtained under normal laboratory conditions, and may vary depending on the conditions of installation. Since the application conditions are not controllable by us, the information on this sheet does not imply responsibility of the company.