• Full application guarantee.
• Adhesive with Gel Technology.
• Multiformat.
• Thixotropic adhesive.
• Ecological.
• Fibroreinforced.

How to use

1. Mix with clean water (7.3 – 8.3 l/bag) mechanically until a homogeneous and workable consistency is achieved.
2. Let the kneaded adhesive rest for 5 min and reknead before application.
3. Spread the paste on the support in cloths not exceeding 2 meters, combing with the appropriate trowel. Follow the instructions for use defined in the UNE-EN 138002 table.
4. Place the ceramic pieces on the fresh gel adhesive, pressing them gently until making complete contact with the entire surface, flattening the grooves.
5. For the treatment of joints between tiles both indoors and outdoors, as well as perimeter and structural joints, follow the instructions for use defined in the tables of the UNE-EN 138002 standard.

Precautions and recommendations

- Do not apply on facades or on poorly cohesive and weak supports.
- Do not apply at temperatures below 5 ºC or above 45 ºC.
- Do not apply with risk of frost or rainy weather.
- For applications on supports or derivatives of gypsum or anhydrite, previously use our adherent primer CAPA PRIMER TOP.
- In extreme weather conditions (wind and temperatures
high) drying occurs faster than normal, causing a reduction in the open time of application.
- In case of high temperatures, wind and very absorbent supports, it is advisable to moisten the support and wait for the disappearance of the water film, before applying the material.
- Periodically check that no surface film has formed on the extended adhesive, in which case it would be necessary to comb or remove it again, applying the product again.
- Check the stickiness of the paste by periodically lifting any tile placed and observing that it is well adhered.
- Apply the product following the indications contained in the UNE-EN 138002 laying regulations and in accordance with the instructions that appear in the technical data sheet. For any questions consult the Technical Department.
- Use it within 1 year from its packaging date and store in a covered and dry place in its original container, protected from moisture.


Capagel Flex Compact is presented in 25 kg bags, formed on shrink-wrapped pallets in 1000 kg, 1400 kg and 1600 kg formats.


The surfaces must be set and clean of dust, paint and oil.
The product can be used on surfaces of laminated plaster or on conventional surfaces such as renders and concrete floors, as well as on aerated concrete.
For applications on surfaces or derivatives of gypsum or anhydrite, previously use our adherent primer CAPA PRIMER TOP.
In case of use on surfaces or with tiles not defined in the material's technical data sheet, consult the Technical Department.
Avoid dead plasters and weak plasters.


The recommendations for use are based on our knowledge and experience. The technical data have been obtained under normal laboratory conditions, and may vary depending on the conditions of use. Since the application conditions are not controllable on our part, the information on this sheet does not imply responsibility of the company.