CapaLechada E20K-E5K

Product made of highly resistant white cement, micronised limestone aggregate, and organic and inorganic additives, to fill joints 0-2 mm wide between ceramic tiles. For indoor use.


CapaLechada E20K-E5K
CapaLechada E20K-E5K
Instructions for use
  1. Mix mechanically with clean water until you obtain a smooth paste of the required consistency.
  2. Leave to stand for 2 – 5 minutes before applying.
  3. Check that joints are clean and free from any dust or adhesive. Moisten the application surface if the weather conditions require it.
  4. Fill each joint with paste using a rubber trowel.
  5. Remove any excess product. Once the product is hard, clean the surface with a damp sponge.
  6. For joints more than 2 mm wide, or for outdoor tiles, use Capa Color.
Warnings and recommendations
  • Do not apply at temperatures below 5°C or above 35°C.
  • Do not apply when frost is forecasted.
  • Avoid applying when direct sunlight is shining on the application surface.
  • Always use the exact required amount of water.
Technical Features

Available Formats

Capa Lechada is sold in 20 Kg paper sacks with plastic sheets, wrapped in pellets of 1,280 Kg (64 sacks). Also in 5 Kg bags (5 bags per box, in pellets of 800 Kg).

Colour Range


The recommendations for use are based on our own knowledge and experience. The technical data provided have been obtained under normal laboratory conditions, and may therefore vary according to the environmental conditions in the place where the product is used. As the application conditions are beyond our control, the information provided here does not imply that the company accepts responsibility for any variations.


Declaraciones Medioambientales

Concienciados con el medioambiente