Caparepar Cosmético R2 Plus

TECHNICAL MORTAR FOR COSMETIC REPAIRS AND LEVELING OF CONCRETE SURFACES

• Light color similar to concrete
• R2 Cosmetic Repair
• Very smooth thin layer
• Fiber reinforced
• Polymerically modified

Caparepar-Copsmetico-R2
Caparepar Cosmético R2 Plus
How to use

1. Gradually add the mortar to the mixing water (5.5 liters per 25Kg bag).
2. Mechanically knead for 2-3 minutes at low speed with clean water until a totally homogeneous mass without lumps is obtained.
3. It will be applied manually by trowel or trowel.

Warnings and recommendations

Do not apply at temperatures below 5ºC or above 35ºC.
Do not apply when rain or frost are forecasted.
The absorbent surfaces will be previously moistened with water until saturation but without stagnation.
This product is ready to mix with water, do not add any kind of additive that could alter its properties.
Under unfavorable conditions (low relative humidity, wind, sun, etc.) curing is essential for at least 24 hours after application.
Do not apply on traffic surfaces.
As it is a cementitious product, the use of rubber gloves is recommended.
The tools and supplies will be cleaned with water immediately after use, if the product hardens they can only be removed by mechanical means.

Packaging

CapaRepar Cosmético R2 PLUS is presented in 25 kg paper bags with anti-humidity plastic sheeting, shipped on 1,050 kg (42 bags) pallets.
Conservation: 12 months from the date of manufacture of the product in adequate conditions of temperature and humidity.

Surfaces

The surfaces must be hardened, dust free, healthy, free of oil, grease, paint and plaster residues.
The absorbent surfaces will be previously moistened with water until saturation but without stagnation, the mortar will be applied when the surfaces acquire a matt colour.

Aplications

Superficial and cosmetic repair of prefabricated parts.
Repair of the detachment of the superficial slurry of the concrete during stripping.
Repair and levelling of damaged concrete surfaces, in structures, pillars, facades, etc.
Repair of edges and small cracks.
Sealing of pores on concrete and mortar supports, filling of hollows and fine gravel nests, etc.
Fine plaster on concrete and mortar.
Applicable indoors and outdoors.
Valid on both vertical and horizontal surfaces.
Suitable for repair work according to principle 3, method 3.1 and 3.3 and for conservation or restoration work on passivation according to principle 7, method 7.1 of the UNE-EN 1504-9 standard.
In the case of applications not defined in this file, consult the Technical Department.

Note

The recommendations for use are based on our knowledge and experience. The technical data have been obtained under normal laboratory conditions, and may vary depending on the conditions of use. Since the application conditions are not controllable on our part, the information in this sheet does not imply responsibility of the company.

ECOETIQUETADO

Declaraciones Medioambientales

Concienciados con el medioambiente