ConstructColor 0-15 E5K
Portland cement mortar with special additives and resistant inorganic pigments, used to ? ll joints 0 – 15 mm wide. Constructcolor 0-15 is suitable for ?lling joints between any ceramic and natural stone tiles. For indoor and outdoor use. Waterproof.
ConstructColor 0-15 E5K
- Mix mechanically with clean water until you obtain a smooth paste of the required consistency.
- Leave to stand for 2 – 5 minutes before applying.
- Check that joints are clean and free from any dust or adhesive.
- Moisten the application surface if weather conditions require it.
- Fill each joint with paste using a rubber trowel. Carry out the ? nishing process once the top of the mortar has started to harden.
- Do not apply at temperatures below 5°C or above 35°C.
- Do not apply when frost or rain are forecasted.• Avoid applying when direct sunlight is shining on the
application surface. - Always use the exact required amount of water.
- For joints exceeding 15 mm in width or depth, add 4 litres of aplica Latex per 20 kg bag and 1 litre per 5 kg bag and ?ll with water until optimal consistency.
R = 1,82 x Z x H x (10/Z + 10/Y). R= Yield: kg/m2
Z: Joint Width in cm
H: Joint Depth in cm
X: Tile Width in cm
Y: Tile Length in cm
1.82: Paste density (kg/l)
Constructcolor 0-15 is available in 5 kg paper bags with plastic lining, dispatched on pallets weighing a total of 800 kg (5 bags per box).
Use within 1 year of packaging date. Store the product in its original sealed packaging in a dry, covered place protected from humidity.
The recommendations for use are based on our own knowledge and experience. The technical data provided have been obtained under normal laboratory conditions, and may therefore vary according to the environmental conditions in the place where the product is used. As the application conditions are beyond our control, the information provided here does not imply that the company accepts responsibility for any variations.
ECOETIQUETADO
Declaraciones Medioambientales
Concienciados con el medioambiente