1. Add water and mix manually or mechanically until a homogeneous and workable consistency.
2. Let the dough rest for 5 minutes and re-knead before applying.
3. Spread the paste on the surface in cloths not larger than 2 m2, combing with the appropriate trowel. If double gluing is necessary, also extend on the back of the piece.
4. Place the ceramic pieces on the fresh product, pressing them gently to achieve complete contact over the entire surface, flattening the grooves.
5. Leave a joint of at least 1.5 mm indoors and 5 mm outdoors. Wait 24 hours for tile grouting and 48 hours for flooring.
6. Respect perimeter and structural joints. In interior pavements, leave partition joints every 50m2 and 30m2 outdoors.

•Do not apply on plaster surfaces and derivatives.
•Do not apply with risk of frost or rainy weather.
•Do not apply at temperatures below 5oC or above 35oC.
•Do not apply in areas where there is a danger of stagnant water.
•In extreme weather conditions (wind and high temperatures) it dries faster than normal, causing a reduction in the application open time.
•In case of high temperatures, wind and highly absorbent
surfaces, it is advisable to moisten the surface and wait for the water film to disappear before applying the product.
•Periodically check that no superficial film has formed
on the extended adhesive, in which case it would be necessary to comb it or remove it and apply the product again.
•Check the stickiness of the paste by periodically lifting any tile placed and observing that it is well adhered.
•Use it within 1 year from its packaging date and store in a covered and dry place in its original closed container, protected from moisture.

Deco Blanco CE is presented in 25 kg paper bags with anti-humidity plastic sheeting, shipped on 1,050 kg (42 bags) pallets.

Conventional surfaces and cement mortar pavements. The surface must be resistant, perfectly set and clean of dust, paint, oil, etc.

Laying underfloor heating, ceramic tile, stoneware, marble, with or without absorption, outdoors and indoors, on cement mortar supports, concrete or plasterboard. Indicated for floors with heavy traffic, covering skirting boards, application on old floors. Placement on radiant heating installations or cooling systems. For formats larger than 40x40, and on facades, the double gluing technique should be used.

The recommendations for use are based on our knowledge and experience. The technical data have been obtained under normal laboratory conditions, and may vary depending on the conditions of use. Since the application conditions are not controllable on our part, the information in this sheet does not imply responsibility of the company.