Deco Porcelánico Blanco C2E

C2E HIGH ADHESION CEMENT-BASED ADHESIVE

Mixed binder adhesive, with high adhesion, especially for laying interior and exterior flooring. For gluing all kinds of ceramic pieces with high wetting capacity.

Deco-porcelanico-web
Deco Porcelánico Blanco
How to use

    1. 1. Add water and mix manually or mechanically until a homogeneous and workable consistency.

 

    1. 2. Let the dough rest for 5 minutes and re-knead before applying.

 

    1. 3. Spread the paste on the support in panels no larger than 2 m2, combing with a 10x10x10 mm trowel. If double gluing is necessary, also extend on the back of the piece.

 

    1. 4. Place the ceramic pieces on the fresh product, pressing them gently to achieve complete contact over the entire surface, flattening the grooves.

 

    1. 5. Leave a joint of at least 1.5 mm indoors and 5 mm outdoors. Wait 24 hours for tile grouting and 48 hours for flooring.

 

    6. Respect perimeter and structural joints. In interior pavements, leave partition joints every 50m2 and 30m2 outdoors.
Precautions and recommendations

• For plaster supports, avoid dead plaster and weak plaster.
• Do not apply with risk of frost or rainy weather.
• Do not apply at temperatures below 5oC or above 35oC.
• In extreme weather conditions (wind and high temperatures) it dries faster than normal, causing a reduction in the application open time.
• In case of high temperatures, wind and highly absorbent supports, it is advisable to moisten the support and wait for the water film to disappear before applying the product.
• Periodically check that no superficial film has formed on the extended adhesive, in which case it would be necessary to comb it or remove it and apply the product again.
• Check the stickiness of the paste by periodically lifting any tile placed and observing that it is well adhered.
• Use it within 1 year from its packaging date and store in a covered and dry place in its original closed container, protected from moisture.

Packaging

DECO CEMENTO COLA PORCELÁNICO is presented in 25 kg paper bags with anti-humidity plastic sheeting, shipped on 1,050 kg (42 bags) pallets.

Surfaces

Conventional surfaces and cement mortar pavements. The surface must be resistant, perfectly set and clean of dust, paint, oil, etc.

Applications

Laying of ceramic tile, stoneware, marble, with or without absorption, outdoors and indoors, on cement mortar supports.
For formats larger than 30x30 cm, the double gluing technique must be used.

Note

The recommendations for use are based on our knowledge and experience. The technical data have been obtained under normal laboratory conditions, and may vary depending on the conditions of use. Since the application conditions are not controllable on our part, the information in this sheet does not imply responsibility of the company.

ECOETIQUETADO

Declaraciones Medioambientales

Concienciados con el medioambiente