• Mechanically mix with clean water until a homogeneous paste of suitable consistency is achieved.
• Let it sit for 2-5 minutes before beginning application. Check that the joints are clean and free of dust or adhesive.
• Pre-moisten if weather conditions require it.
• Apply the paste to the joints with a rubber float until the joint is filled.
• Immediately remove most of the joint residue, leaving only a thin film on the tile.
• Finish once the surface has hardened.
• Begin cleaning as soon as the joint has thickened. For final cleaning, use a sponge moistened with clean water, thick enough to avoid damaging the joints.

• Do not apply when there is a risk of frost or rain.
• Do not apply when temperatures are below 5°C or above 35°C.
• In extreme weather conditions (wind and high temperatures), the product dries more quickly than normal, resulting in a reduction in open time.
• In cases of high temperatures, wind, and highly absorbent substrates, it is advisable to moisten the substrate and wait for the water film to disappear before applying the product.
• Grouting on still-damp substrates causes variations in the joint.
• Clean the newly applied joint with a damp sponge to rehydrate it.
• Go over the joint several times with a trowel to achieve good penetration.
• Do not use on joints greater than 5 mm in floors or walls where specific chemical resistance or water absorption is required; For filling elastic expansion joints on highly deformable substrates that are not completely dry and are subject to capillary rise.
• Protect the joint from rain and direct sunlight for at least 12 hours after application.
• Use within 2 years of the packaging date and store in a covered, dry place in its original, sealed container, away from moisture.

Aplica Color Fina 0-4 is packaged in 5 kg plastic bags: 5 bags/box, 25 kg/box, 32 boxes/pallet.
Use within 2 years of the packaging date and store in a covered, dry place in its original, sealed container, away from moisture.

Calculadora de consumos de morteros de juntas