Aplica Refractario
Mortar made of aluminous cement, special aggregate and additives which make it resistant to high temperatures.
Masonry mortar resistant to high temperatures
Aplica Refractario
- The surfaces must be rough, hard, stable, clean, and free
from dust, paint and released agents. - Mix preferably in an electric mixer at low rpm, adding
water gradually until you obtain a smooth, lump-free
paste. - Leave the paste to stand for 2 minutes and mix again
before applying. Moisten the mortar 24 hours after
application.
- Do not apply onto plaster.
- Do not apply this product when frost or rain are
forecasted. - Do not apply at temperatures below 5ºC or above 35ºC.
- It is advisable to moisten absorbent or very hot surfaces
before applying the product in order to prevent the
mortar from becoming overly dry or less strong. - This product is ready to mix with water. Do not add
any kind of additional substance which may alter its
properties. - Use within 1 year of packaging date. Store the product
in its original sealed packaging in a dry, covered place
protected from humidity.
aplica Refractario is available in 25 kg paper sacks with moisture-proof plastic lining, dispatched on shrink-wrapped pallets weighing a total of 1,600 kg (64 sacks).
For laying, grouting and assembling refractory bricks (fire bricks). Common tasks where the use of refractory mortar is required. Masonry tasks when in contact with aggressive water, containing sulphates or with a pH of more than 5.
The recommendations for use are based on our own knowledge and experience. The technical data provided have been obtained under normal laboratory conditions, and may therefore vary according to the environmental conditions in the place where the product is used. As the application conditions are beyond our control, the information provided here does not imply that the company accepts responsibility for any variations.
ECOETIQUETADO
Declaraciones Medioambientales
Concienciados con el medioambiente