For application in the following situations: Increase the adhesion of substrates.
Facilitate connecting bridge in repairs and/or overlaps between waterproofing membranes.
Note: consult with our technical department about the application in other types of media or situations

• One-component, solvent-based polyurethane resin with high solids content, which once dry forms a continuous film with great adhesion on supports such as concrete, mortar or wood, increasing adhesion for liquid waterproofing systems.
• Its consumption depends on the situation of the support, irregularities it presents or level of planimetry. It ranges between 100-200 g/m²/layer. Apply a thin layer, never thick.
• In repairs and membrane overlaps its consumption is between 50-100 g/m².
• The application must be carried out in conditions of no presence of humidity in the substrate or water coming from the substrate or extrados, either at the time of application or a posteriori (pressure due to water table). Possibility of applying in combination with mineral fillers (aggregate of silica) on very irregular supports.
• It can be diluted with AplicaPROOF SOLVENT if necessary for poorly absorbent substrates (max. 5-7%).

It is presented in two formats of 5 kg metal containers.

Shelf life is 12 months stored at a temperature between 5 ºC to 35ºC in dry locations. Once the container is opened, it must be used.

Recommendations for use are based on our knowledge and experience. The technical data has been obtained under normal laboratory conditions, and may vary depending on the conditions of installation. Since the application conditions are not controllable by us, the information in this sheet does not imply the responsibility of the company.