Aplica Glass

Adhesive made of highly resistant cements and hi-tech polymers, for the perfect laying and grouting of glass blocks.

aplica Glass contains water-repellent additives, which make it highly water resistant.

Aplica Glass
Aplica Glass
Instructions for use

  1. Add water and mix by hand or mechanically until you obtain a smooth paste of a workable consistency.
  2. Leave the paste to stand for 5 minutes and mix again before applying.
  3. Spread the paste over the sides of each glass block, as with conventional bricks.
  4. Lay the blocks row by row, using separators between each block to make sure that all the joints are of the same size. At the same time, reinforce the joints with galvanised stee rods.
  5. Fill joints which have not been perfectly filled.
  6. Finish the joints using a fine damp sponge.
  7. After 24 hours, clean again to remove any Capa Glass that has stuck to the blocks.
Warnings and recommendations
  • Do not apply this product when frost or rain are forecasted.
  • Do not apply at temperatures below 5°C or above 35°C.
  • In extreme weather conditions (wind or high temperatures), the product will dry more quicker than usual. This will result in a shorter open time application.
  • In high temperatures, windy conditions or if the application surface is very absorbent, it is advisable to moisten the surface and wait for the film of water to disappear before applying the product.
  • Use within 1 year of packaging date. Store the product in its original packaging in a dry, covered place protected from humidity.
Technical Features

Available Formats

aplica Glass is available in 25 kg paper sacks with moisture-proof plastic lining, dispatched on pallets weighing a total of 1,600 kg (64 sacks).

Application Surfaces
  • Glass blocks. Stable conventional surfaces and cementbased mortar floors.
  • The application surface must be hard, perfectly set and free from dust, paint, oil, etc.
  • Assembling and grouting glass blocks.
  • For indoor and outdoor use.
  • Fast-dry.
  • Can be used with rods.
  • Construction of large windows, dividing walls and partitions.

The recommendations for use are based on our own knowledge and experience. The technical data provided have been obtained under normal laboratory conditions, and may therefore vary according to the environmental conditions in the place where the product is used. As the application conditions are beyond our control, the information provided here does not imply that the company accepts responsibility for any variations.


Declaraciones Medioambientales

Concienciados con el medioambiente