Two component acid-resistant sealer-adhesive. This two- component product is based on epoxy resins, selected quartz and special additives. It is suitable for gluing and grouting floors and different types of ceramic coverings on a wide range of surfaces. It has excellent waterproofing qualities, as well as resistance to chemical and mechanical damage. Provides rapid drying without shrinkage, and is easy to wash with water. APLICACER COLOR EPOXI 5.0 is available in different colours which will highlight the beauty of the surface, guaranteeing a resistance to ageing and clean joints that cannot be achieved with traditional sealers

APLICACER COLOR EPOXI 5.0 is not an elastic product and, for this reason, supports need to be fixed and rigid rather than subject to movement beyond the normal oscillations and vibrations of the actual structures. Therefore, lightweight or fine prefabricated panel supports are not suitable. Before application, the joints need to be completely clean and any excess cement needs to be removed along the whole thickness of the floor tile. There should be no dust, oil or other adhesive substances present. It is also important that the joints and the grout used for laying the tiles are both dry. A very important condition for obtaining good results with APLICACER COLOR EPOXI 5.0 is environmental temperature, as this will have a considerable influence on the application time for the product and the time it takes before it can be walked on; in fact, at 20oC (the ideal temperature for using the product without complications) the application time is approximately 30 minutes, adjustment time is around 60 minutes and an approximate time of 24 hours before it can be walked on; at 25oC these values increase considerably, and allow for normal traffic after a period of 80 hours, while at temperatures above 30oC the usage time is too short.

APLICACER COLOR EPOXI 5.0 is a special product created from two components based on epoxy resins, selected quarts and special additives. It is suitable for gluing and grouting flooring and different types of ceramic coverings on a wide range of surfaces and has excellent waterproofing qualities and resistance to chemical and mechanical damage. APLICACER COLOR EPOXI 5.0 has been created to be quick-drying without shrinkage. It can be washed easily with water and is available in different colours which will highlight the beauty of your coverings, guaranteeing the kind of resistance to ageing and clean joints that are not achievable with traditional sealers.

Use for gluing floors and ceramic coverings of all types (except those with absorbent surfaces) up to 20 mm thick on: - food industry surfaces (dairies, slaughterhouses, wineries, meat processing or cheese-making factories); - swimming pools and tanks containing aggressive chemical liquids; - laboratory benches, kitchen surfaces, hospitals; - surfaces where a high-quality, hard-wearing easy to clean and attractive covering is required.

APLICACER COLOR EPOXI 5.0 is sold in 5kg tubs containing 2 pastes which have been pre-measured in the correct proportions (paste A 4650 g and paste B 350 g). These pastes need to be mixed thoroughly in the original container with clean, dry tools until a complete mix of both pastes is achieved. Do not add water or any other substance to the product as this will damage it beyond repair. During mixing, placing and sponge cleaning, always use rubber gloves, as Paste B is a skin irritant.

The data and information contained in this technical sheet is based on our experience and is therefore purely indicative. The product user must check this and must accept all responsibility for its use.