Aplicagel FLEX PREMIUM C2TES1
HIGH FLEXIBILITY, ULTRA THIN, FIBER REINFORCED, CREAMY AND WITH GEL TECHNOLOGY, WHICH GIVES IT AN EXCELLENT WORKABILITY.
• Overlaying and special large formats.
• Fibroreinforced.
• Thixotropic and special high thickness adhesive.
• Ecological and compatible with plaster supports.
• Dust reduction by 90%.
Aplicagel FLEX PREMIUM
- Mix with clean water (8.5 - 9.5 l/sack) mechanically until obtaining a homogeneous and workable consistency.
- Allow the kneaded adhesive to rest for 5 min and re-knead before application.
- Spread the paste on the support in cloths not exceeding 2 meters, combing with the appropriate trowel. Follow the instructions for use defined in the UNE-EN 138002 table.
- Place the ceramic pieces on the fresh gel adhesive, pressing them gently until making complete contact with the entire surface, flattening the grooves.
- For the treatment of joints between tiles both
indoors and outdoors, as well as perimeter and structural joints, follow the indications for the use of nests in the tables of the UNE-EN 138002 standard.
• Do not apply on poorly cohesive and weak supports.
• Do not apply at temperatures below 5 oC or above 45 oC.
• Do not apply at risk of frost or rainy weather.
• For applications on supports or derivatives of gypsum or anhydrite, previously use our adherent primer APLICA PRIMER TOP.
• In extreme weather conditions (wind and high temperatures) drying occurs faster than normal, causing a reduction in the open application time.
• In case of high temperatures, wind and very absorbent supports, it is advisable to moisten the support and wait for the water film to disappear before applying the material.
• Check the stickiness of the paste by periodically lifting any installed tile and observing that it is well adhered.
• Apply the product following the instructions included in the installation regulations UNE-EN 138002 and
technique. For any questions, consult the Technical Department.
• Use it within 1 year from its packaging date and store in a covered and dry place in its original container, protected from humidity.
Aplicagel Flex Premium is presented in 25 kg BOPP bags, formed on shrink-wrapped pallets in 1000 kg, 1400 kg and 1600 kg formats.
The surfaces must be set and clean of dust, paint and oil. Avoid dead plasters and weak plasters.
The product can be used on surfaces made of laminated plaster, plaster and derivatives of plaster or on conventional surfaces such as plaster and concrete floors, as well as on aerated concrete.
In case of use on surfaces or with tiles not defined in the material's technical data sheet, consult the Technical Department.
The recommendations for use are based on our knowledge and experien- ce. The technical data have been obtained under normal laboratory conditions, and may vary depending on the conditions of use. Since the application conditions are not contro- llable on our part, the information in this file does not imply responsibility of the company.