100% solids-based epoxy resin for substrates with high levels
of humidity

• Primer with very high resistance to humidity (up to 98 %)
• Suitable for PU and PUA base membranes

AplicaPROOF PRIMER WET is a solvent-free, low viscosity, one- coat epoxy resin. It is specially designed to increase the adhesion of our waterproofing systems based on continuous membranes, AplicaPROOF and AplicaFLOOR and AplicaPROOF COAT floor coatings, on concrete, mortar or ceramic substrates with high residual humidity.


Epoxy resin to be used mainly in:
• Concrete, mortar or ceramic substrates with high humidity or residual water on the surface in the case of "green concrete".
Note: consult our technical department for application on other types of substrates or settings


Kit comprising metal containers:
COMPONENT A: 11.95 kg + COMPONENT B: 3.05 kg

General characteristics

• 100% solids-based aromatic epoxy resin, solvent-free and odourless. Do not add water or solvents of any kind.
• Removes residual moisture from mortar or concrete substrates (up to 98%).
• Applicable on porous substrates such as concrete, mortars and ceramics to provide excellent adhesion.
• Respect existing structural joints (do not cover with AplicaPROOF PRIMER WET).
• It is applied with a notched trowel (consumption of approximately 400 g/m2, thickness 270 microns).
• Do not use with phreatic water pressure (water pressure coming from the bottom of the treated element).


12 months at a temperature of 5 oC to 35 oC, always stored in dry places. If the container is opened it should be used immediately.


The recommendations for use are based on our knowledge and experience. The technical data have been obtained under normal laboratory conditions and may vary depending on the conditions of installation. As the conditions of application are beyond our control, the information in this sheet does not imply any liability on the part of the company.


Declaraciones Medioambientales

Concienciados con el medioambiente