aplicaRev Cal Revoco

Mortar made with non-hydraulic lime, for the rendering of façades. Perfect for restoring or renovating old façades. Impermeable, breathable and mass-coloured, suitable for different types of finish. Trowelled, fine combed, polished and smooth. Apply manually or mechanically.

Fine lime mortar for decorating and protecting façades. For indoor and outdoor use. Classified as CR-CSI-W2 in accordance with Standard UNE-EN 998-1.

aplicaRev Cal Revoco
aplicaRev Cal Revoco
Instructions for use

  1. Check that the application surface is suitable and ready for use.
  2. Mix mechanically, adding water gradually until you obtain a smooth, lump-free paste of the required consistency.
  3. We recommend levelling the surface before application (luting).
  4. Apply evenly, then level out the mortar, covering the surface with a minimum thickness of between 7 mm and 9 mm.
  5. Finish the mortar as desired.
Warnings and recommendations
  • Do not apply onto plaster or painted surfaces.
  • Do not apply this product when frost or rain are forecasted.
  • Do not apply at temperatures below 5ºC or above 35ºC.
  • In joints between different materials or where there is a risk of cracking, reinforce the mortar with a fibreglass net.
  • If greater thicknesses are required, apply in layers 15 mm thick.
  • It is advisable to moisten absorbent or very hot surfaces before applying the product and 24 hours afterwards in order to prevent the mortar from becoming overly dry or less strong.
  • Do not apply onto waterproofed surfaces.
  • This product is ready to mix with water. Do not add any kind of additional substance which may alter its properties.
  • Use within 1 year of date of packaging. Store the product in its original sealed packaging in a dry, covered place protected from humidity.
Technical Features

Available Formats

aplicaRev Cal Revoco is available in 30 kg paper sacks with moisture-proof plastic lining, dispatched on shrink-wrapped pallets weighing a total of 1,260 kg (42 sacks).

Application Surfaces
  • Old lime surfaces, cement mortars, mixed mortars, brickwork and concrete blocks.
  • The surfaces must be resistant, hard, stable, in good condition and free from any oils and grease.
  • Lime rendering mortar for the decoration of façades. Impermeable and offering different finishes: trowelled, fine combed, polished and smooth.
Colour Range


The recommendations for use are based on our own knowledge and experience. The technical data provided have been obtained under normal laboratory conditions, and may therefore vary according to the environmental conditions in the place where the product is used. As the application conditions are beyond our control, the information provided here does not imply that the company accepts responsibility for any variations.


Declaraciones Medioambientales

Concienciados con el medioambiente